Vent Hood Template - Bosch AQ4 Installation Manual

Horizontal vent kit

Table of Contents

8 V e n t h o o d m o u n t i n g

1. Use scissors to detach template. Verify external vent hood installation clearances on page 5 (Fig. 1) are adhered to. Attach the

vent hood mounting template to the interior of the wall the vent hood will be penetrating.

2. Verify that wall penetration will not come in contact with concealed wiring or plumbing. Using a 1/2" drill bit, drill two pilot holes

where noted on the template. The drill bit must be long enough to penetrate to the building exterior.

3. Attach the template to the building exterior aligning the pilot holes on the template with the pilot holes drilled in step 2.

4. Using a reciprocating saw, cut an opening through the building siding, wall board, etc., following the lines of the template.

5. Slide the vent hood through the opening and fasten to exterior wall using provided screws.

6. Once power venter is completely installed and secured, apply a bead of exterior rated caulk between vent hood flange and exterior

of building.

CUT HOLE THROUGH WALL

PILOT

HOLE

WHEN INSTALLING THE VENT HOOD FOLLOW THE BACK DRAFT FLAPPER

INSTRUCTION SHEET IF OUTDOOR TEMPERATURES MAY DROP BELOW FREEZING

Fig. 14 Vent hood mounting template

TEMPLATE

WASHER (4)

SHEET METAL SCREW (4)

NOTE: HARDWARE SHOWN INCLUDED

WITH VENT HOOD