Siemens SIMATIC Box PC 620 Getting Started page 2

Safety guidelines
This Getting Started contains notices intended to ensure personal safety, as well as to protect the products and
connected equipment against damage. These notices are highlighted by the symbols shown below and graded
according to severity by the following texts:
Danger
!
indicates that death, severe personal injury or substantial property damage will result if proper precautions are not
taken.
Warning
!
indicates that death, severe personal injury or substantial property damage can result if proper precautions are not
taken.
Caution
!
indicates that minor personal injury can result if proper precautions are not taken.
Caution
indicates that property damage can result if proper precautions are not taken.
Notice
draws your attention to particularly important information on the product, handling the product, or to a particular
part of the documentation.
Qualified Personnel
Repair, maintenance and servicing of device only to be carried out by qualified personnel. Qualified persons are
defined as persons who are authorized to commission, to ground and to tag circuits, equipment, and systems in
accordance with established safety practices and standards.
Correct Usage
Note the following:
Warning
!
This device and its components may only be used for the applications described in the catalog or the technical
description, and only in connection with devices or components from other manufacturers which have been
approved or recommended by Siemens.
This product can only function correctly and safely if it is transported, stored, set up, and installed correctly, and
operated and maintained as recommended.
Trademarks
SIMATICR, SIMATIC HMIR and SIMATIC NETR are registered trademarks of Siemens AG.
Third parties using for their own purposes any other names in this document which refer to trademarks might in-
fringe upon the rights of the trademark owners.
Copyright E Siemens AG 2002-2003 All rights reserved
The reproduction, transmission or use of this document or its
contents is not permitted without express written authority.
Offenders will be liable for damages. All rights, including rights
created by patent grant or registration of a utility model or design, are
reserved.
Siemens AG
Organization Group Automation and Drives
Division Systems Engineering
Postfach 2355, D- 90766 Fuerth
Siemens Aktiengesellschaft
Disclaim of Liability
We have checked the contents of this manual for agreement with the
hardware and software described. Since deviations cannot be pre-
cluded entirely, we cannot guarantee full agreement. However, the
data in this manual are reviewed regularly and any necessary cor-
rections included in subsequent editions. Suggestions for improve-
ment are welcomed.
E Siemens AG 2002-2003
Technical data subject to change.
A5E00131477 03