Operating Conditions At The Installation Site; Mounting To Linear Actuators - ABB TZID-C110 Short Manual

3.1.2 Operating conditions at the installation site

Before installing check to ensure that the specifications in terms of safety
and control applicable to the TZID-C110 will not be exceeded.
Warning
Ambient temperature:
Relative humidity
Explosion protection:
Mounting position:

3.1.3 Mounting to linear actuators

A special attachment kit is available for mounting the positioner to a linear actuator
according to DIN/IEC 534 (lateral mounting to NAMUR) comprising the following parts:
3.8
3.9
3.10
3.7
Tools required: Wrench 10 mm/13 mm
41/18-77 EN
-40 ... +85 °C (-40 ... +185 °F)
< 75% (95% for a short time), non-condensing
Observe the specifications for protection class
IP65 / NEMA 4X
Observe the specifications in the certificate, see section
"Certificates" on page 29.
any orientation allowed, provided that the splash guard
cap is in place, see section "Mounting the splash guard
cap" on page 15.
3.4
3.5
3.0
3.1 3.2 3.3
2.1
2.2
2.0
Allen key 4 mm
Installing and commissioning
Installing and commissioning
• Lever (1.0) w. follower
pin, for 10...35 mm or
25...90 mm actuator
stroke
• Follower guide (2.0)
with two screws (2.1)
and clamp plates (2.2)
1.0
• Angle
with two screws (3.1),
two spring washers
(3.2), and two plain
washers (3.3)
• Screw (3.4) and plain
washer
mounting to cast iron
yoke
• Two U-bolts
each with two nuts
(3.8),
washers
two plain
(3.10) for mounting to
columnar yoke
bracket (3.0)
(3.5) for
(3.7),
two spring
(3.9), and
washers
5