Using The Machine; Before Use - Stiga RECYCLING VE32 Instructions For Use Manual

EN
4 DESCRIPTION
4.1 Controls
4.1.1 Electric socket and relieving loop
The machine must be connected via an
earth leakage circuit breaker with fault
current 30 mA. There is otherwise a
risk of fatal electric shocks.
The connection cable is connected to the ma-
chine's electric socket (3:N). The cable must then
be secured in the relieving loop (3:K) before it
leaves the machine.
4.1.2 Start and stop control
Start:
1. Tilt the machine until the front wheels rise
about 5 cm from the ground.
2. Press in and hold the button (3:P)
3. Squeeze the handle (3:O).
4. Release the button (3:P).
5. Let the front wheels down.
Stop:
1. Release the handle (3:O).
4.1.3 Height adjustment
The spiral cutter can be set to 6 different height po-
sitions according to the table below. Change posi-
tion as follows:
1. Pull out the lever (4:Q).
2. Set the lever to the desired position.
3. Release the lever so that it locks in the new po-
sition.
Spiral cutter's position
Transport position.
13 mm above the ground.
Cleaning position A.
3 mm above the ground.
Cleaning position B.
At ground level.
28
ENGLISH
Cuts 3 mm down into the
lawn.
Cuts 6 mm down into the
lawn.
Cuts 10 mm down into the
lawn.
5.1 Vertical cutting
Making vertical cuts in the lawn achieves the fol-
lowing benefits:
Lever's position
• The air can penetrate down into the soil layer,
• Loose moss can be scarified and gathered in the
• The grass roots are divided, so increasing in

5.2 Before use

When performing vertical cutting, the grass must
be as short as possible, ideally not more than 4 cm
long. Vertical cutting can be carried out with or
without a collector. If the collector is not used, the
waste will be dropped and distributed evenly be-
hind the machine.

5 USING THE MACHINE

The machine must be connected via an
earth leakage circuit breaker with fault
current 30 mA. There is otherwise a
risk of fatal electric shocks.
Never run over the extension lead. Risk
of fatal electric shocks.
making it easier for moisture to evaporate. This
counteracts the growth of moss.
collector.
number. This produces a denser lawn with more
blades of grass.