Contemporary Controls Metasys JC-MER-CXB User Manual page 29

4. Use the JC-MER-CXB Planning Form B to generate a new
router file. The file should be a list of subnet address and IP
address pairs of the form:
where "nnn" is the subnet address and "xxx.xxx.xxx.xxx" is the
IP address for the JC-MER-CXB attached to that subnet. The
last line of the router file should be a line containing "000."
Once you have built a new router file that lists all of the subnets,
a copy must be placed in each JC-MER-CXB attached to the
system.
5. Configure the new hardware and install it as described in a
previous section, Adding a New Metasys ARCNET Subnet.
6. Use the JC-MER-CXB Planning Form B to update the TCP/IP
configuration on each of the existing JC-MER-CXB units. The
procedure for updating the TCP/IP information is described in a
previous section, Changing the Ethernet Network.
7. To update the DDL files for Metasys, use the JC-MER-CXB
Planning Form A. The only changes you should have to make
are to the Network Definition and the Global Definition DDL
files to change the subnet addresses for each NCM and each
PCI/OWS. If you add new NCMs to the system, you will most
likely update the DDL files to add the data base information for
the new NCMs when you update the subnet and node addresses
for the Metasys devices.
nnn xxx.xxx.xxx.xxx
TD060100-0MA
29