Contemporary Controls Metasys JC-MER-CXB User Manual page 27

6. Modify the information in each JC-MER-CXB using the
configuration program. Add a new line to the screen that lists
the subnet address and the IP address for the new router. For
example, if you are adding subnet number 12 with IP address
192.168.22.236, add the following line:
Add the new line before the line containing the three zeros (000).
After you have edited the screen, save its information using the
save command (Ctrl-K, S). Then use the download program to
copy the new address information to all of the JC-MER-CXB
devices used in the system.
To download the new information, reboot the JC-MER-CXB that
contains the new configuration and after the router has started
running, enter download at the prompt. Follow the instructions
provided and note any messages displayed. After the new
configuration has been successfully downloaded to all other
routers, reboot the originating router by typing in reboot.
Note: The IP address of the router with the new configuration
must appear in the configuration screen of every other
JC-MER-CXB in the network. A receiving router will
not accept information from a device that is not listed
in its existing configuration screen.
7. Add the new NCM or PCI/OWS to the new ARCNET segment
by following the procedures for adding an NCM or PCI/OWS to
an existing ARCNET segment, as described previously.
12 192.168.22.236
TD060100-0MA
27