Connection Of The Earth Connection Element - dehn HVI Conductor Installation Instructions Manual

6. Connection of the earth connection element

The earth connection element of the HVI
lug/earth entry rod.
The end of the HVI Conductor/HVI
®
ded. The HVI Conductor/HVI
®
tion element (see Fig. 5, page 11).
Special tools (HVI cutter, (Part No. 597 032) should be used to cut the HVI
®
Conductor to length!
To mount the earth connection element, the insulation of the HVI
imust be removed by 35 mm.
Recommended tools:
HVI Condcutor: HVI

®
HVI power Conductor: HVI

®
After removing the insulation, the earth connection element is mounted on the conductor ends of the
®
HVI Conductor/ HVI
The following steps must be observed (see also Fig. 5, page 11):
Position the earth connection element above the HVI

it clockwise onto the relevant conductor end as far as it will go. To this end, an open-end wrench
(wrench size 19) can be used on the wrench contact surface of the earth connection element.
Subsequently, tighten the two threaded pins using a tightening torque of 5 Nm. Thus, the copper

conductor of the HVI
currents).
Conductor/HVI
®
power Conductor can be shortened on site, but it cannot be exten-
®
power Conductor must be prepared for contact with the earth connec-
®
strip 20, Part No. 597 220.
®
strip 27, Part No. 597 227.
®
®
power Conductor.
® Conductor is safely electrically connected (capable of carrying lightning
power Conductor is connected to a terminal
®
Conductor/ HVI
®
®
Conductor/HVI
10
Conductor/HVI
® ®
power Conductor
®
®
power Conductor and turn
Publication No. 1565 / UPDATE 04.18
power