Related Manuals for Aseko PP60 pH
Summary of Contents for Aseko PP60 pH
- Page 1 POOL TECHNOLOGY The pool water pH controller PP60 pH User’s manual Tel.: +420 244 912 210 Email: aseko@aseko.cz aseko.com Stránka z ...
- Page 2 Installation Install of the PP60 pH unit to filtration system is shown in Fig. 1. PP60 pH requires connection to the water from pool. Connect the water supply to PP60 pH after the pump and before the filter. Injection valve from the PP60 pH must be placed after the filter.
- Page 3 POOL TECHNOLOGY Fig.1. Connection to the filtration system Hose fixation to dosing valve to probe well to water intake Fig. 2. Tel.: +420 244 912 210 Email: aseko@aseko.cz aseko.com Stránka z ...
- Page 4 POOL TECHNOLOGY First start The first start of the PP60 pH should be in the fresh water without any additional chemicals. Turn on the PP60 pH by plugging it into a power socket. You can move in the settings by the key MODE, the values displayed for particular items can be set by the keys + and -.
- Page 5 Install your PP60 pH indoor away from dust and high humidity and make sure all electrical connections are secure. Do not open your PP60 pH or exchange any of the internal parts. This will damage the electrical integrity of PP60 pH. The chemicals used with the PP60 pH must be handled in ...
- Page 6 Check the clear plastic tubes inside the dosing pumps are not damaged or broken. • To remove your dosing pumps from your PP60 pH, disconnect the clear plastic tubes, turn your dosing pump anti clockwise and pull away from your PP60 pH.
Need help?
Do you have a question about the PP60 pH and is the answer not in the manual?
Questions and answers