Pentair Myers BX Series Installation And Service Manual
Pentair Myers BX Series Installation And Service Manual

Pentair Myers BX Series Installation And Service Manual

Industrial pumps

Advertisement

Quick Links

MODEL BX
INDUSTRIAL PUMPS
INSTALLATION AND SERVICE MANUAL
NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible
party who maintains the system.
Part # 13800A903 | © 2012 Pentair Pump Group, Ltd. | 11/12/12

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Myers BX Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Pentair Myers BX Series

  • Page 1 INSTALLATION AND SERVICE MANUAL NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible party who maintains the system. Part # 13800A903 | © 2012 Pentair Pump Group, Ltd. | 11/12/12...
  • Page 2: General Instructions

    GENERAL INSTRUCTIONS E. Make sure that drive is adequate for horsepower required and that drive is properly aligned and Reciprocating pumps of both the plunger and piston tensioned. With belt drives, pulley on both motor type are positive displacement in principle. Due to and pump should be located as close as possible positive displacement characteristics, problems may to bearing to reduce bearing and shaft bending...
  • Page 3: Specifications

    5. Make sure all valves, including spray gun or SAE 40 should be used. Use only good quality grade nozzles, are open in discharge line. Spray gun oils with SAE designation MS, SC or SD. Maintain may be anchored to discharge back into tank. level at mark on cover for the required RPM.
  • Page 4: Valve Service

    SERVICE MANUAL erosion is present on valve. All valve components are interchangeable but it is recommended to put them CAUTION: Disconnect electrical leads to motor back in the same order as taken out if not renewing to remove spark plug leads on engine before the components.
  • Page 5 SERVICING CONNECTING LINK REPLACING CROSSHEAD SEALS The connecting links should be checked for bearing With the crankshaft and crossheads removed, the wear only if the pump shows signs which might be worn seals can be pried out. When installing new due to a failing link or during a general overhaul.
  • Page 6 BX6-12 INDUSTRIAL PUMP PARTS LIST 13800A903 11/12/12...
  • Page 7 BX8-15 INDUSTRIAL PUMP PARTS LIST 13800A903 11/12/12...
  • Page 8 (f) if unit is used for purposes other than for what it is designed and manufactured; (g) to any unit that has been repaired or altered by anyone other than Pentair Myers or an authorized Pentair Myers service provider;...

This manual is also suitable for:

Myers bx6-12Myers bx8-15

Table of Contents