IBM Power System S814 Installing page 33

v A unique name that is not currently registered in the DNS for any other IP address.
2) If you are using IBM i V6R1, or later, press the Tab key. The Service TCP/IP Address field is
enabled.
3) Specify the service TCP/IP address. Enter the LAN console adapter IP address.
4) Click Next.
e. Specify the LAN console interface information.
1) In the Service TCP/IP Address field, type the IP address that you recorded.
2) In the Service Subnet Mask field, type the subnet mask that you recorded.
3) In the Service gateway address field, type the default gateway that you recorded.
4) The system serial number must match the tag on the server. It must be 7 characters long,
without a dash.
5) Set the Target partition to 1.
6) Click Next.
f. Specify the device ID. If you are prompted to specify a service tools device ID, enter QCONSOLE.
Click Next.
g. Click Next > Finish. Your session is now ready to connect. Double-click the session name to start
the connection.
7. Power on the server by completing the following steps:
a. Set the manual initial program load (IPL) by completing the following steps:
1) Locate the server's control panel. Look for the blue tab on the front of the server. Push it to
the side, and pull the control panel out slowly.
2) Press the Up arrow key until you see 02, and press Enter.
3) Press Enter again. A < (less than symbol) appears next to N.
4) Press the Up Arrow key. The N changes to an M.
5) Press Enter.
6) Press Enter twice. A 02 is displayed on the control panel.
b. After you have the server set to a manual IPL, push the white power button to power on the
server.
Note: You must watch the control panel while the system is trying to power on. During the IPL, the
system displays C6004031 indicating that it is searching for console. The system might take 20 - 30
minutes to complete this action. If A6005008 is displayed, this means that no console is available.
This might indicate that the system is not preinstalled with IBM i and you must set the console type
to LAN.
8. Perform this step if the system is not preinstalled with IBM i. For setting the console type to LAN,
complete the following steps:
a. Set the control panel to manual mode. If the system is in Normal mode (function 01 shows 01 B
N), select function 02 on the control panel and press Enter.
b. Enable control panel functions by completing the following steps:
1) Select function 25 on the control panel and press Enter. The return code must be 00.
2) Select function 26 on the control panel and press Enter.
Note: If you see a FF return code, go back to function 25 and press Enter, then return to
function 26 and press Enter.
c. Check your current setting(s). Use console service functions (65+21+11) to check the current
setting.
v A600 500A = No console defined
v A601 500A = Twinax console
Installing the IBM Power System S814 (8286-41A)
17