Advertisement
OPERATING INSTRUCTIONS
FIRST TIME USE
Remove all packing and materials. Be sure that all parts are included before discarding any
packaging.
1. Pull out the power cord from the compartment under the base, and place base on a flat
surface.
2. Open the lid then fill water into the kettle.
3. Fill kettle to the maximum level mark (for first time use only) with fresh tap water.
4. Close the lid and place the kettle back on the base unit, and plug into a power outlet.
5. Switch the kettle on by pressing the switch to the "I" position, the blue LED light inside the
glass jar will illuminate to indicate the water is heating.
6. The kettle will automatically switch to the "O" position once the water has boiled and the
blue LED indicator light has gone off.
NOTE: Wait 30–60 seconds if you need to heat the water immediately after a boiling cycle.
7. Empty the kettle then wash the glass jar with water, repeat the above 2 times.
NOTE: Never allow the water to fill above the maximum level or lower than the minimum
level indicated on the glass jar.
MAKING TEA
1. Remove tea infuser from kettle by grasping the tea infuser insert and lifting up.
2. Add fresh, cold water to the kettle, filling it for the number of cups of tea you wish to
make—up to 4 cups (max fill for tea is 1 Liter).
3. Insert tea infuser into the kettle and ensure it is securely in place.
4. Once water has boiled, open lid and carefully add tea leaves or tea bags to the tea infuser.
Securely close the lid. Warning: Use extreme caution when adding tea leaves. The kettle is
very hot.
5. CAUTION: Wait until unit has completely cooled before removing tea infuser.
Tea infuser will be very hot after use; may cause serious burns if not handled properly.
GENERAL USE
For everyday use follow steps 1-6 listed above to ensure best results.
The power source will only work if the kettle is placed directly on the base unit.
MODEL: RJ11-17-TI
4
Hide quick links:
Advertisement
