Table of Contents
Advertisement
How to connect power line and thermistor cable
Please note：
Electrical installation should only be done by a licensed electrician
Remove the piping cover and screw clamp fitting.
Connect the power supply line to the terminal block.
Hold the power supply line below the terminal block with the screw clamp fitting.
Connect the thermistor cable line to the terminal block.
Fix the thermistor cable with the code clip and conduit clip.
Attach the piping cover back on the heat pump unit.
Figure 10: Connect power cables
25mm or less
Sanden Heat Pump – Installation Manual
Page 12 of 32
Hide quick links:
Advertisement
Table of Contents
