Advertisement
Checking the reference position
1.
Change the mode to [CHR] and pull the crown out to position
2 .
The second and function hands and dual time indication point to 0 position
and stop.
2.
Press and hold the lower right button A .
The hands and indication start to move to the current reference positions
stored in memory.
• Release the button as the hands start to move.
3.
Check the reference position.
Correct reference positions:
• Hour, minute and second hands: 0 hour
00 minute 0 second
• Date indication: midway between "31"
and "1"
• Function hand: "0.0" (straight above)
• Dual time indication: 0 hour 00 minute
When the current reference position is
different from the correct one, proceed
to step 3 of "Correcting the reference
position".
4.
Push the crown in to position 0 .
5.
Change the mode to [TME] to finish the procedure.
Correcting the reference position
1.
Change the mode to [CHR] and pull the crown out to position
2 .
The second and function hands and dual time indication point to 0 position
and stop.
2.
Press and hold the lower right button A .
The hands and indication start to move to the current reference positions
stored in memory.
• Release the button as the hands start to move.
3.
Press and release the lower right button A .
The function hand slightly moves and the hand and date indication become
adjustable.
4.
Press and release the lower right button A repeatedly to
change the hand/indication to be corrected.
• Each time you press the button, the target changes as follows:
Function hand/date indication → Dual time indication →
Hour and minute hands → Second hand → (Back to the top)
• The hands slightly move when selected to show they become adjustable.
5.
Rotate the crown to adjust the hand/indication.
• When you rotate the crown quickly a few times, the hand/indication will
move continuously. To stop the rapid movement, rotate the crown in either
direction.
6.
Repeat steps 4 and 5.
7.
Push the crown in to position 0 .
8.
Change the mode to [TME] to finish the procedure.
Resetting the watch — All Reset
1.
Change the mode to [CHR] and pull the crown out to position
2 .
2.
Press and hold buttons A and B at the same time for 4
seconds or more and release them.
Alarm sounds as the buttons are released and the hands move to their
current reference position.
The setting values after All Reset
Calendar
January of leap year (5-second position)
World time
Time zone (offset) 0 (LON), London
Reception result
NO
Summer time
OFF at all time zones
Alarm setting
OFF
Alarm time
0:00 AM
Leap seconds
No change after All Reset
Rollover number
After All Reset
After All Reset, adjust the reference position, set the time and calendar and
execute alarm setting.
F950 Abbreviated instruction
Advertisement
