Overview - Emerson Rosemount 928 Wireless Gas Monitor Quick Start Manual

October 2019
1

Overview

The Rosemount
Series of sensor modules.
The sensor fits integrally into the transmitter without the use of tools. Make
electrical connections when the sensor module is fully seated in the
transmitter sensor housing.
Note
Use Rosemount 928 only with the Rosemount 928 Transmitter.
CAUTION
The Ingress Protection (IP) filter must be installed.
If the IP filter is not installed, damage may occur to the sensor inside the
Rosemount 628.
Do not operate the transmitter without the correct IP filter installed in
the sensor module.
When installing the IP filter, verify that the IP filter gasket is in place, is
properly aligned, and that it does not block the white filter media. Refer
to Figure
When handling the IP filter, avoid contact with the filter media.
Verify that all three legs are fully latched by pushing upward on each leg
of the IP filter.
Avoid getting water inside the IP filter.
Do not attempt to clean the IP filter.
Do not rinse or spray the IP filter with water.
Do not immerse the IP filter in water.
Quick Start Guide
™
928 Wireless Gas Monitor is used with the Rosemount 628
1-1.
Quick Start Guide
5