Adjusting The Back Height - Invacare Matrx MX1 User Manual

7. Repeat STEPS 1-6 to install the back onto the remaining band clamp.
It may be necessary to slide the angle adjustable brackets

H to allow the clamp body to properly align with the band
clamp.
8. Adjust the back shell I so it is centered between the back canes J.
9. Tighten the eight screws K securing the angle adjustable brackets
H to the back shell.
I
J
Part No. 1176090
H
K
J
17
4.8

Adjusting the Back Height

1. Loosen the compression bar hardware A.
2. Adjust the back to the desired height.
 Height adjustments must be made equally on both back
canes.
3. Tighten the compression bar hardware to secure the clamp bodies
B in place.
 When re-tightening the compression bar hardware,
alternate back and forth between the screws until the
compression bar is fully secured.
B
A
4 DUAL MOUNT
Invacare® Matrx® MX1