Invacare Matrx MX1 User Manual page 10

3 MONO MOUNT
4. Position the rigidizer bracket B at a 45° angle to the band clamp.
5. Align the edges of the clamp with the corresponding slots E in the
rigidizer bracket.
6. Carefully slide the rigidizer bracket onto the band clamp.
7. Ensure the clamp is fully engaged in the slots in the rigidizer bracket.
8. Insert the two locking pins F into the rigidizer bracket to hold the
band clamp in place.
9. Ensure the pins are fully inserted into the rigidizer bracket.
 The pins should slide into position with little effort. If the
pins are difficult to insert, verify that the band clamp is
properly centered and fully seated inside the slots of the
rigidizer bracket.
B
4
5
C
D
E
3
Invacare® Matrx® MX1
STANDARD
INSTALLATION
8
F
OPTIONAL INVERTED POSITION
FOR 9" (23 CM) TALL BACKS
D 3
C
B
10. Center the bracket between the back canes.
11. Tighten the compression bar hardware A just snug enough to hold
the bracket assembly in place.
 Do not fully tighten the compression bar at this time.
12. Install the tracking plate. Refer to Installing the Tracking Plate on
the Back Shell on page 11.
11
A
10
E
F
A
Part No. 1176090