Table of Contents
Advertisement
Display stamping
You can configue the device so that the camera name, device
name, time and alarm source are displayed in the video image.
Select top if the names are to be displayed at the top of the image,
or bottom if the names are to be displayed at the bottom of the
image. If you do not wish the names to be displayed, select off.
Camera name stamping:
Camera name is displayed in the left-hand corner of the video
image.
Time stamping:
Date and time are displayed in the right-hand corner of the video
image.
Alarm mode stamping:
Select On to permanently display the alarm source (e.g. video
signal) in the video image for information.
Select Off to never display the alarm source or On alarm if the
alarm source is only to be displayed in the event of an alarm. Or
select On alarm hold if the alarm source is to continue to be dis-
played even after the end of the alarm status or until it is confirmed.
VideoJet 400
Configuration with web browser
39
Advertisement
Table of Contents
