Running A Job, Continued - Lincoln Electric SPIRIT II Series Quick Start Manual

Running a job (continued)
Follow the steps below to Jog the tool around the table
Incremental Jog:
Pressing one of the arrows on the screen will move the torch-
body in the direction you are pressing, the amount of distance
specified in the "Increment Distance" setting.
By using the slider, you can set increments between .000 -
.100". You can directly enter any number into the dialog.
Set Program Zero:
This establishes the Lower Left corner of the program, centerline
of the torch body. This will be where the job will start from for any
part or nest programmed for the Torchmate 5100 .
Establish the plates position by pressing SET PROGRAM ZERO.
Go To Program Zero:
This will move the torch body back to the established PROGRAM
ZERO, at the highest possible torch position to avoid torch collisions.
7
Quick Start Guide, Spirit II