Advertisement
Plasma Console
Plasma Console: (Spirit II)
The Spirit II plasma cutter allows you or the G-Code program to set variables for the plasma cutter. All of the plasma cut-
ter buttons and information screens are only displayed on the HMI Plasma Console, there are no buttons, regulators, etc.
on the Spirit II plasma cutter.
•
Material - Choose the type of material
•
Preflow - Digital Read Out for Preflow gas pressure, this is set automatically by the selection of the material, thick-
ness, and amperage
•
Thickness - Choose the thickness of your material
•
Plasma (Gas) - Pressure and type of gas, this is set automatically by the selection of the material, thickness, and am-
perage
•
Current - This will automatically set to the recommended current based on your chosen material type and thickness.
This is done for the "optimum" cut quality. This can be overridden to increase production while reducing cut quality.
•
Shield (Gas) - Pressure and type of gas, this is set automatically by the selection of the material, thickness, and am-
perage
•
View torch Parts - Will provide the operator an exploded view of the consumables required for the selected material
and thickness, with part numbers (displayed on next page)
•
Display Process Gases, Cut or Mark - Displays the preflow, plasma, and shield pressures for the Cutting or Marking
Process.
•
Grey/Green Power Button - Turns the Spirit II plasma cutter ON (green) or OFF (grey)
•
Process Setup Material/Parameters - Material displays the Material Selection screen (shown below), Parameters dis-
plays the actual cut parameters for the selected material and thickness (displayed on next page)
•
System - Access different system variables for the Spirit II plasma cutter
Torchmate 5100
8
Advertisement
