About Electricity Connecting - Hoover HDI 2T1045 Instruction Manual

Dishwasher must be level for proper dish rack operation and wash performance.
1
Place a spirit level on door and rack track inside the tub as shown to check that the
dishwasher is level.
2
level the dishwasher by adjusting the three levelling legs individually.
3
When level the dishwasher, please pay attention not to let the dishwasher tip over.
Figure 8
Illustration of feet adjustment
NOTE:
The maximum adjustment
height of the feet is 50 mm.

About Electricity Connecting

WARNING! WARNING!
For personal safety:
Do not use an extension cord or an adapter plug
n n
with this appliance.
Do not, under any circumstances, cut or remove
n n
the earthing connection from the power cord.
Electrical Requirements
Please look at the rating label to know the rating voltage and connect the dishwasher to the appropriate power supply.
Use the required fuse 10 amp, time delay fuse or circuit breaker recommended and provide separate circuit serving
only this appliance.
Ensure that proper
earthing exists
before use
Check level Front to Back
Electrical Connection
Check power supply. Voltage, frequency and phase must correspond to that specified
on the unit rating plate. Only insert the plug into an electrical socket which is earthed
properly. If the electrical socket to which the appliance must be connected is not
appropriate for the plug, replace the socket, rather than using a adaptors or the like
as they could cause overheating and burns.
Spirit level
Check level side to side
22