Wash Cycle Table; Changing The Program Mid-Cycle; At The End Of The Wash Cycle - Hoover HDI 2T1045 Instruction Manual

Changing the Program Mid-Cycle

Premise:
1 A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
2 Open the door ,press the Program button more than 3 seconds , the machine will be in standby state,
then you can change the program to the desired cycle setting (see the section entitled " Starting a
wash cycle. . ." ).
NOTE: NOTE:
If you open the door during a wash cycle , the machine will pause. The program light will
stop blinking and the buzzer will mooing every minute unless you close the door . After
you close the door ,the machine will keep on working after 10 seconds.
Forgot to Add a Dish? Forgot to Add a Dish?
A forgotten dish can be added any time before the detergent cup opens.
1
Open the door a little .
2 After the spray arms stop working, you can open the door
completely.
3
Add forgotten dishes.

At the End of the Wash Cycle

At the End of the Wash Cycle
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to break. They will also dry better.
Switching Off the Dishwasher
The program light is on but is not blinking, only in this case the programme has ended.
1.Open the door.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to shocks. The dishes should cool down for around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal for the dishwasher to be wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
It is dangerous to open the door mid-cycle,
WARNING! WARNING!
as hot steam may scald you.
4
Close the door
5
The dishwasher will run after 10 seconds.
14