Start Up / Operation; Start-Up; Operation; Power Switch - Hussmann HGM-3 BS Installation & Operation Manual

P/N 0515297_E
START UP
1. Check the cabinet thoroughly for loose
nuts and bolts and electrical connections.
Inspect the refrigeration lines for any vis
able damage or chafing.
2. Replace the electrical box cover.
3. Start the merchandiser and allow the
merchandiser to pull down to operating
temperature.
The merchandiser must operate for 24 hours
before loading product. Regularly check
temperatures. Do not break the cold chain.
Keep products in cooler before loading
merchandiser. These merchandisers are
designed for pre-chilled product only.
Product will be degraded and may spoil if allowed to sit
in a non-refrigerated area.
Under normal conditions, after the cabinet is
installed and running, very little maintenance
should be required. Follow the list of instruc-
tion below after initial startup and for periodic
maintenance purposes.
1. Check operation of condenser fan motors.
Fan blades must turn freely.
2. Check drain pan and heater to prevent
accidental overflow.
3. Make sure doors are closing properly and
that the gaskets seal.
4. Make sure all evaporator fan motors are
running. These can be seen through the
grille inside the cabinet.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.

START UP / OPERATION

OPERATION

Power Switch

The power switch is located at the electrical
box behind the top, decorative panel (TS models)
or bottom louvered panel (BS models). The
switch will shut off all power to the merchandiser.

Light Switch

Each HGM model has a convenient ON/OFF
switch so lights may be turned off to conserve
energy during hours when the store is closed.
The switch only controls the lights.
...ATTENTION
INSTALLER
It is the contractor's responsibility to install
merchandiser(s) in accordance with all local
building and health codes.
3-1
HGM Merchandisers