Pentair Pool Products Nocchi R2T Use And Maintenance Manual page 3

1. GENERAL INFORMATION
1.1 Documentation supplied
1.1.1 Manual
Data
Instruction manual
Edition 1
Version 0102
Code 253P4250
Addressees
This manual is addressed to the operators responsible for
operating the machine during all the technical stages of its life.
Contents
This manual contains the following information:
- Manufacturer's declaration
- Safety information
- Commercial information
- Information on documentation
- Machine description
- Transportation information
- Storage information
- Installation information
- Information on adjustments
- Operational information
- Maintenance information
- Dismantling information
Information is divided into the following chapters and
appendices of this manual:
Chapter 1 : General information
Chapter 2 : Description
Chapter 3 : Installation
Chapter 4 : Operation
Chapter 5 : Maintenance
Chapter 6 : Operating problems
Chapter 7 : Dismantling
Appendix : Product specifications
1.2 Ownership of information
The information contained in this manual is property of
PENTAIR WATER ITALY Srl.
It is forbidden to reproduce in whole or in part this manual
without the explicit authorisation of PENTAIR WATER ITALY
Srl.
The information contained in this manual is related only to the
machines indicated in section "Product Specifications".
PENTAIR WATER ITALY reserves the right to make the
changes deemed necessary to the machines not listed in the
"Machine identification data".
1.3 Machine identification data
Machine code
Circulating pump
2 = two-pole motor
4 = four-pole motor
Coupling to standard motor
Twin type
Rated diameter of mouths
Max head (in dm)
Special version (only on

request )
Rated pressure (bar)
R 2 T D 65 - 60 X
1.4 EC compliance declaration
See page 2
1.5 General safety information
It is advisable to carefully follow the instructions contained in
this manual with specific reference to notes, warnings and
danger signs.
Attention Users should always follow the accident
prevention laws in force in the country
where the product is installed.
Danger Before
electropump, disconnect it from the socket
and/or turn the main switch to Off (when
present) to interrupt the power supplied to
the
electropump from accidentally restarting
and from causing accidents to people
and/or damages to the people.
Danger Do
electropump while it is powered, because
these
accidents or even death.
Attention During operation, do not remove or move
the electropump.
Danger Before using the electropump, always
check that the cable and all electric devices
are efficient, shielded and protected.
Danger When
inserting the plug into the socket and/or
turning the main switch to on), always wear
shoes and make sure that the hands are
dry.
Failure to follow the safety procedures and
precautions
NOTE
documentation
PENTAIR WATER ITALY from all liability
thereof.
6
repairing or servicing
electropump. This
not service, install or move the
operations can cause
starting the electropump
contained
supplied
the
prevents the
serious
(by
in the
shall relieve