Advertisement
Supplied Items
E-bidet (Seat Unit)
Water Supply Hose and Clip (Standard
39354SH0/39414SH0 model only)
Corporation Cock (Standard 39354SH0/39414SH0
model only)
Remote Control
Screws, Anchors, and AA Batteries (For Remote
Control)
Anti-theft Nut, Screw, and Washer (For Remote
Control)
Power Socket
Ceramic Bowl
Protection Sheet, Mounting Bases and Washers (For
Ceramic Bowl)
Spray Hood
Banderole
Strainer (Display [18801SH0] model only)
Installation kit for automatic flush (Item No. 46 944)
Adaptor Valve for 4.5 L cistern (Item No. 42 333)
• Flushing Cable is an optional item that is sold separately.
Necessary Tools
Spanner (19 mm)
Monkey Wrench
Crosshead Screwdriver
Flat-blade Screwdriver
Flat-blade Precision Screwdriver (2.5 mm)
Crosshead Precision Screwdriver (No. 0)
Ratchet (19 mm)
Grinder
Pipe Cutter
Level
File
Tape
Ruler
Pen
Hammer
Utility knife
Adhesive
Preparations
Turn off the power breaker.
For the GROHE water supply tank
Remove the pipe cover.
For other water supply tanks
Cut out the wall.
Adjust the length of the bolts protruding from the wall.
Pull the power cord out from the wall.
Thread the power cord into the power socket parts,
and connect the wires.
Note
• Make sure to attach the wires into the corresponding
inlets.
Fasten the parts of the power sockets together.
Note
• Tighten the pieces securely.
Remove the inspection chamber cover.
Preparing the Water Supply Hose
Detach the cap and two components from the water
supply hose.
Thread the water supply hose up to the water shutoff
valve.
Attaching the Corporation Cock
Close the water shutoff valve, and detach the water
supply hose.
Attach the corporation cock to the water supply hose
on the filling valve side, and attach the other end of
the corporation cock to the water shutoff valve.
Reattach the two components of the water supply
hose, then attach the water supply hose to the bottom
of the corporation cock.
Place a water receptacle beneath the water supply
hose.
Open the water shutoff valve, and rinse out any trash
within the water supply hose.
Check for water leaks around the water shutoff valve
areas.
Note
• If there is a leak, tighten the leaking area securely.
Close the water shutoff valve.
11
GB
Advertisement
