Panasonic WE-MV180A Service Manual page 6

Rear View
1
IN
2
@2 S-Video Input Connectors (S-VIDEO IN 1, 2)
The S-Video signal from an external source is supplied to
these connectors.
@3 Composite Video Input Connectors
(VIDEO IN 1, 2)
A composite video signal from the external source is sup-
plied to these connectors.
Note:
When both the S-video input connector and the com-
posite video input connector are used at the same
time, only the S-video connector is selected for the
input source.
@4 Audio Input Connectors (AUDIO IN R/L 1, 2)
The audio signal from the external source is supplied to
these connectors.
Button Address Label (supplied
accessory)
To help locate the WHITE BALANCE, NEGA and FRAME
MEMORY buttons from the top of the stage, apply the button
address label on the stage as shown below.
AUDIO
S-VIDEO VIDEO
R
L
Button
Address Label
VIDEO OUT
SYNC B G R
@5 RGB Video Output Connectors (SYNC/R/G/B)
These connectors are used for connection to a monitor
or projector provided with an RGB input connector.
Cautions:
• To prevent signal loss, use a BNC cable that is no
longer than 3 meters (not supplied). If the BNC cable
is longer than 3m, use a cable compensator.
• Connect the SYNC connector to a monitor that is
provided with an RGB connector.
3