Grinding With The Dry Grinding Disc; Grinding With The Wet Grinding Disc; Change Grinding Disc - Parkside PNTS 250 B1 Translation Of The Original Instructions

G B I E
N I
Grinding with the dry
grinding disc
• Place the workpiece on the workpiece
support ( 6) and slowly bring it to its
desired angle on the dry grinding disc
( 5).
to side in order to achieve an optimal
ing disc is worn uniformly. Occasion-
ally, allow the workpiece to cool down.
• Fold the spark protection device (
downwards while grinding in order to
avoid injury from sparks.
Grinding with the wet
grinding disc
• Check the water level in the water tank:
submerged in water up to the water level
mark on the water tank (
• Stand in front of the wet grinding disc
( 1).
• Hold the workpiece with both hands
and lower it slowly onto the wet grind-
ing disc.
on the teeth of the water tank (

Change grinding disc

Information on replacement:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed
stated on the grinding disc is the
same or higher than the nominal
rotation speed of the device.
• Ensure that the grinding disc
dimensions match those of the
device.
1 4
.
1) is to be
• Never re-drill a locating hole which
• Never use separate bushings or
• Do not use any saw blades.
2)
• Always reassemble the device
13). Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when
changing the grinding discs in or-
der to avoid cutting damages.
13).
Change dry grinding disc:
1. Remove the spark protection (
.
3. Unscrew the grinding disc
(sound test: an undamaged grind-
ing disc hanging freely on a string
will result in a clear sound if it is
tapped with a plastic hammer).
is too small to make it larger.
adapters in order to make grind-
ing discs whose hole is too large
.
.
must be made of elastic materials
e.g., rubber, soft cardboard etc.
completely after replacing the
grinding disc.
.
move the dry grinding disc cover
( 4) from the protective hood
(25).
nut (22) with a screw wrench
the grinding disc with one hand
wearing a glove.