Table of Contents
Advertisement
Quick start guide — Putting a device into commission
Put the device into
commission
Put the wireless operating unit into commission
Display lighting
When not in use, the display lighting automatically goes off after approx. 30 s.
By pressing the OK button, the display lighting is switched on again.
1. Insert the batteries into the battery compartment of the wireless operating unit (observe
polarity!). The wireless operating unit is automatically recognised due to the hardware ID
entered in the GPA.
2. Wait for the initialisation phase. This can take up to five minutes. After successful
initialisation, the following appears in the display of the wireless operating unit:
22:30
Symbol
Meaning
Fault
Symbol
blinks
If the initialisation is unsuccessful, please repeat step 1.
In addition, compare the hardware ID in the GPA with the hardware ID on the
device label. Note that any change in the GPA requires a re-commissioning of the
project.
Put the wireless magnetic contact into commission
1. Lower the sliding cover of the wireless magnetic contact to better recognise the LED status.
2. Pull out the protective strips of the batteries on the wireless magnetic contact.
3. Wait for the initialisation phase. The LED status flashes red/green alternately for approx.
ten seconds and then turns off.
After successful initialisation, the following appears in the display of the wireless operating
unit:
22:30
Symbol
Meaning
Alarm device open The wireless magnetic contact indicates "Door or window
If the initialisation is unsuccessful, please remove the batteries and insert them
again. In addition, compare the hardware ID in the GPA with the hardware ID on the
device label.
Cause
The housing cover of the alarm control unit is open and
the wireless operating unit is not attached to the mounting
frame.
For the functionality test, the cause does not have to be
eliminated.
Cause
open" because the magnet is not applied to the wireless
magnetic contact.
8
Advertisement
Table of Contents
