Table of Contents
Advertisement
Quick start guide — Setting up the security system
I want to quickly
test the security
system Alarm
Connect. What do
I need to do?
Here goes!
Set up, put into commission and test a small security system
Alarm Connect
For quick set-up and functional testing, the security system Alarm Connect has the following
three devices:
• 1 x alarm control unit Connect (mandatory).
• 1 x wireless operating unit (mandatory).
• At least one alarm detector (here: 1 x wireless magnetic contact as a trigger).
Prepare the alarm control unit Connect
1. Unpack the alarm control unit Connect.
2. Push the housing cover up until the screws that are integrated into the hinged cover of the
battery compartment are exposed and the housing cover is noticeably blocked. The housing
cover is now in Position 1.
Betriebsmodus = Position 0 & 1
3. Loosen both screws and remove the housing cover. The hinged cover on the battery
compartment can be opened. The housing cover can only be pushed up beyond Position 1
if the two screws were loosened before! The alarm control unit Connect is only in
configuration mode once the housing cover has been removed! Do not reinsert and slide
down the housing cover.
Konfigurationsmodus = Position 2
LAN
4. Connect the battery pack and the mains voltage.
5. Connect the commissioning PC to the alarm control unit Connect via Ethernet cable:
• One-to-one connection via the LAN port of the alarm control unit Connect or
• Via the local network.
GPA
Configuration mode of the alarm control unit Connect
For the configuration mode of the alarm control unit Connect, the following applies:
• All security areas are disarmed.
• The internal battery pack and the mains voltage are connected.
• The housing cover is removed.
LAN
Position 0
Position 2
N
L
N
L
Position 1
Position 0
LAN
LAN
AMT TEL
A
B
B2
A2
Akku
RS485
RS485
RS485
12V GND A1 B1
12V GND A2 B2
12V GND A3 B3
GPA
Ahnjy9eWVgNt+bgz
KNX Secure 1
FDSK 1
AAEBBI-IACHKM-G0SW2M-
SUESVI-3K1PFN-FHZVQF
LAN
N
L
N
L
Position 1
Position 0
LAN
N
L
N
L
N
L
N
L
N
L
Bereich
Linie
RS485
INPUTS
OUTPUTS
TLN-Nr.
12V GND A4 B4
12V GND IN1 IN1
12V GND OUT1 OUT2
IP
S
IP Adr.
Ort/Notiz
Gira, Dahlienstraße
42477 Radevormwald
Germany
Gira Contr. panel
MAC-Adr. LAN
XX:XX:XX:XX:XX:XX
MAC-Adr. WLAN
XX:XX:XX:XX:XX:XX
AC 230 V
5
Advertisement
Table of Contents
