Accessories; Warranty; English - Kärcher HDS-C 9/15 Original Instructions Manual

Fault Possible cause
Plant is not running Mains fuse have got triggered
No pressure build- Amount of water supply is too low.
up in the plant or
Pipe is blocked
pump is knocking
System is sucking air
Only HDS-C 7/11, HDS-C 9/15: Heating coil
has heavy calcium deposits
Pump leaky (more Defective pump part
than 3 drops of wa-
ter per minute)
Detergent is not Filter or hose is blocked
taken in
Backflow valve stuck
Solenoid valve is defective
High pressure Detergent container is empty
pump is sucking in
air.
Only HDS-C 7/11, Washing programme with hot water not se-
HDS-C 9/15: Burn- lected.
er does not ignite
Water shortage
or the flame glows
off during opera-
Fuel filter dirty
tion
No ignition
Too low water tem- Temperature has been set too low.
perature for hot
Nozzle in spray pipe is rinsed out.
water operations
Only HDS-C 7/11, HDS-C 9/15: Heating coil
has heavy calcium deposits
Only HDS-C 7/11, HDS-C 9/15: Heating coil
sooted

Accessories

Attachment sets
Sticker Operating Instructions
German,Order.-Nr.: 5.391-558.0
English, Order no.: 5.391-559.0
French, Order no.: 5.391-560.0
Italian, Order no.: 5.391-561.0
Spanish, Order no.: 5.391-562.0
Portuguese, Order no.: 5.391-563.0
Dutch, Order no.: 5.391-564.0
Greek, Order no.: 5.391-565.0
Polish, Order no.: 5.391-566.0
Water filter G 1"
Order no.: 6.414-278.0
Lance holder
Order no.: 2.641-310.0
Hose holder
Order no.: 2.641-320.0
Coin acceptor
Order no.: 2.641-297.0
Coin counter
Order no.: 2.641-333.0
Faults without display
Remedy
Check mains fuses and mains voltage
Check water supply level (refer to technical data).
Check all pipes to see that there are no blockages
Check system for leaks, the detergent suction hoses
must lie in the detergent, refill detergent container.
Softening using RM 110 is not working. Rectify cause,
decalcify the plant.
Replace defective part.
Clean the parts.
Remove suction hose from pump head and loosen the
recoil valve using a blunt object.
Replace valve.
Refill detergent.
Select another washing programme.
Check water supply, check connections, clean water
shortage safeguard.
Change fuel filter.
Check ignition.
Check ignition electrodes.
Set the thermostat to a higher level.
Define the quantity to be transported by the pump. Re-
place nozzle if the specifications given in the technical
data are exceeded with a large margin.
Softening using RM 110 is not working. Rectify cause,
decalcify the plant.
Remove the soot from the heating coil.
Fuel
Engine oil Hypoid SAE 90
Order no. : 6.288-020.0
Engine oil 15W40
Order no. 6.288-050.0
Silicon grease
Order no. : 6.288-072.0
Lock grease
Order no. : 6.288-116.0
Steel care product
Order no. : 6.290-911.0
Softener liquid RM 110
For softening
Detergent
WARNING
Note the packaging information before us-
ing the detergent.
Do not use the following detergents:
– Detergents containing nitric acid
– Detergents containing active chlorinate
Using such detergents will damage your
equipment.
11
-
EN
RM 806 ASF, 1+3
HDS-C 9/15
HDS-C 7/11
HDS-C 8/15-E
Lime solvent
RM 100 ASF
RM 101 ASF

Warranty

The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of your accessory within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication. In the event of a warran-
ty claim please contact your dealer or the
nearest authorized Customer Service cent-
er. Please submit the proof of purchase.
By whom
Operator
Operator
Operator
Operator
Operator, Cus-
tomer Service
Customer Ser-
vice
Operator
Operator
Customer Ser-
vice
Operator
Operator
Operator
Operator
Customer Ser-
vice
Customer Ser-
vice
Operator
Operator
Customer Ser-
vice
Customer Ser-
vice
Dosing ml/
min
120...150
98...120
110...135
27