Three Year Limited Warranty; Error Codes - DeWalt DW0165S User Manual

Three Year Limited Warranty

D WALT will repair, without charge, any defects due to faulty materials or workmanship for three years from the date
E
of purchase. This warranty does not cover part failure due to normal wear or tool abuse. For further detail of warranty
coverage and warranty repair information, visit www.D
warranty does not apply to accessories or damage caused where repairs have been made or attempted by others. This
warranty gives you specific legal rights and you may have other rights which vary in certain states or provinces.
In addition to the warranty, D
D WALT will maintain the tool and replace worn parts caused by normal use, for free, any time during the first year after
E
purchase.
If you are not completely satisfied with the performance of your D
can return it within 90 days from the date of purchase with a receipt for a full refund - no questions asked.
RECONDITIONED PRODUCT: Reconditioned product is covered under the 1 Year Free Service Warranty. The 90 Day
Money Back Guarantee and the Three Year Limited Warranty do not apply to reconditioned product.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call 1-800-4-D
or visit your local service center for a free replacement.

Error Codes

If INFO appears on the display window with a Code number, perform the corresponding Corrective Action.
Code Description
101 Received Signal Too Weak,
Measuring Time Too Long
102 Received Signal Too High
201 Too Much Background Light
202 Laser Beam Interrupted
203 Insufficient Power
301 Temperature Too High
302 Temperature Too Low
401 Hardware Error
402 Unknown Error
E
WALT tools are covered by our:
®
E
1 YEAR FREE SERVICE
90 DAY MONEY BACK GUARANTEE
Corrective Action
Use the target plate or change the target surface.
Target is too reflective. Use the target plate or change the
target surface.
Reduce the background light on the target area.
Remove the obstacle and repeat the measurement.
Replace the batteries.
Allow the device to cool down to a temperature within the
specified Operating Temperature Range.
Allow the device to warm up to a temperature within the
specified Operating Temperature Range.
Switch the device on/off several times. If the error still occurs,
return the defective device to the Service Center or distributor.
Refer to the Warranty.
Contact the Service Center or distributor. Refer to the Warranty.
WALT.com or call 1–800–4-D
WALT Power Tool, Laser, or Nailer for any reason, you
E
WALT (1–800–433–9258). This
E
E
WALT
E
9