7.
Place the new print head on its support,
seating it on the two pins.
8.
Thread
the new cable the same way as the old, securing
it under
the
tabs on the print head carriage.
9.
Plug the cable into the connector,
inserting
it as far as it will go.
L
Fl
Connector
cover
I
igure 5-2. Replacing
the print head
10. Fasten
the print head down with the two screws.
11. Move the carriage back toward the right and replace the connector
cover.
Slide the connector
cover to the left until it locks into place.
12. Replace
the ribbon
cartridge
and top cover, and plug the power cord
back in.
47