Table of Contents
Advertisement
SECTION V.
TYPE 214-2 CARD READER/PUNCH
REFERENCE EDGE INDICATOR (PUNCH)
Start Procedures
1.
To perform an initial start following a central processor power up:
a.
Press the POWER ON switch.
b.
Press the RUNOUT switch.
This action resets error-check
conditions and clear s the card path.
c.
Load the input deck into the input hopper face down, nines
edge first.
d.
Press the START switch.
If it is desired to stop the reader/
punch while read or punch operations are in progress, the
STOP switch may be pressed.
Restart Procedures
1.
To restart following a STOP switch depression (a normal stop with no
error conditions indicated):
a.
Press the START switch.
2.
To restart following a stop condition for a CARDS indication:
a.
Refill the empty input hopper or empty the full output stacker
as required, and/ or insure the cards are pressed against the
stacker-pressure switch.
NOTE:
When the reader/punch is running, care should be
taken in removing cards from the output stacker
to avoid a possible CARDS indication and a sub-
sequent halt.
b.
Press the START switch.
3.
To restart following a stop condition for an INPUT indication:
a.
Remove the cards from the input hopper.
b.
Check the device for a card jam condition.
The cards causing
the feed failure are nearest the throat (as the deck is removed).
These cards mayor may not be damaged or bent out of shape.
5-6
- - " -
i
I
Advertisement
Table of Contents
