Table of Contents
Advertisement
SECTION III.
TYPE 123 CARD READER
NOTE: As in procedure 5-c above, the card registered at
the wait station is not read upon depression of the
RUNOUT switch.
d.
Reload (with the remainder of the deck) the error card and the
last card in the output stacker, respectively, as the first two
cards in the input hopper.
e.
Press the START switch.
If
rereading the cards fails and the
cards are in registration, the projector lamp may require
replacement by a service engineer.
7.
To restart following a stop condition for a POWER, PICKER, or HEAT
indication on the auxiliary control panel:
a.
Press the POWER OFF switch.
b.
Attempt to correct the condition causing the indication.
In the case
of a POWER indication, one of the logic power supplies has failed
or one of the logic power circuit breakers has opened, in which
case the operator may reset the circuit breaker.
In the case of a
PICKER or HEAT indication, the operator may repeat the initial
start procedure previously described.
c.
If
any of the indications persists after performing an initial start
procedure, a service engineer should be called.
3-10
Advertisement
Table of Contents
