Table of Contents
Advertisement
Federal Communications Commission
Radio Fre
3
uency Interference
tatement
This equipment generates and uses radio frequency energy and if not installed and used
properly, that is, in strict accordance with the manufacturer's
instructions, may cause in-
terference to radio and television reception. It has been type tested and found to comply
with the limits for a Class B computing device in accordance with the specifications
in
Subpart J of Part 15 of FCC Rules! which are designed to provide reasonable protection
against such interference
in a residential installation. However, there is no guarantee
that interference
will not occur in a particular installation. If this equipment does cause
interference
to radio or television reception, which can be determined
by turning the
equipment off and on, the user is encouraged to try to correct the interference
by one or
more of the following measures:
0 Reorient the receiving antenna
0 Relocate the computer with respect to the receiver
0 Move the computer away from the receiver
0 Plug the computer into a different outlet so that computer and receiver are on dif-
ferent branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television techni-
cian for additional suggestions.
The user may find the following booklet, prepared by
the Federal Communications
Commission helpful: "How to Identify and Resolve Radio-
TV Interference
Problems."
This booklet is available from the U.S. Government
Printing Office, Washington,
D..C., 20402, Stock No. 004-000-00345-4.
--
For compliance with Federal Noise Interference
Standard, this equipment requires a
shielded cable.
This statement will be applied only
for
the printers marketed in U.S.A.
Self Declaration
Radio interferences
regarding
this equipment has been eliminated
according to Vfg
lOr6/1984 announced by the DBP.
DBP has been informed about the introduction of this special equipment and has been
conceded the right to examine the whole series.
It is upon the responsibility of the user to assume that his own assembled system is in ac-
cordance with the technical regulations under Vfg 1046/1984.
To observe FTZ-regulations
it is necessary, to establish all connections to the printer
with shielded cable.
The equipment may only be opened by qualified service representatives.
This statement will be applied only
for
the printers marketed
in
West Germany.
Trademark Acknowledgement
NB-15
*'f
rafstar: Star Micronics Co., Ltd.
Apple,
pple ll , Apple II+, A ple ll e, Applesoft: Apple computer Inc.
Commodore C-64: Commodore
usmess Machmes, Inc.
8.
Corn aq: Compaq Computer Corporation
CP/& Digital Research
EasyWriter: Information Unlimited Software, Inc.
IBM Personal Computer, IBM PC: International
Business Machines Corp.
Kaypro: Kay
Microsoft B
ro Corporation
R SIC: Microsoft Corporation
Osborne 1: Osborne Computer Corporation
WordStar: MicroPro International
Corporation
TRS-80: Radio Shack, a division of Tandy Corporation
SuperCalc: Sorcim Corporation
NOTICE
l Al1 rights reserved.
Reproduction
of any part of this manual in any form what-
soever, without STAR'S express permission is forbidden.
@The contents of this manual are subject to change without notice.
l Al1 efforts have been made to ensure the accuracy of the contents of this manual at
the time of going to press. However, should any errors be detected, STAR would
be greatly appreciate being informed of them.
l The above notwithstanding,
STAR can assume no responsibility
for any errors in
this manual.
@Copyright 1986 Star Micronics Co., Ltd.
-
-
-
Advertisement
Table of Contents
