Table of Contents
Advertisement
7)
Cover the structural kit with the padding by adjusting it as shown in Pic. 3.
8)
Place the cover back onto the structure. There are elastic sides that can be securely positioned by pulling
the drawstring provided.
9)
Once the pelvis positioning system has been assembled, have the user to be seated at least for one hour
and verify if the new seat is causing pressure redness on the skin. If this happens it is recommended to adopt
the most suitable interventions in accordance to the specifics defined for the user by the professional operator
under his sole responsibility. On a contrary case, instead, proceed with the delivery of the product to the user.
10)
It is advisable to keep documentary records of each operation carried out, as well as to provide the user with
any deprived/removed parts which can be useful for after delivery interventions and/or adjustments.
Before to use the product have the professional user to show the procedures for a correct commissioning and
maintenance.
It is strongly recommended to periodically check the skin of the user in order to verify any risk of
redness appearance.
11)
When all operations of preparation of the kit to the shape and measures of the user have been accomplished
and the positioning system is ready to be delivered, it is possible to remove the excess of padding from the
edges by using a cutter. Take care to follow the direction of the cut as in the original design.
In relation to the modification, processing and / or adaptation operations carried out on the structural
kit and padding, the upper surface of the cover could result larger compared to the dimensions of the
seating configuration obtained. Take care to spread the surface well when the user is sitting, in order
to avoid wrinkles
2.
Maintenance and cleaning
In order to avoid the development of infections, it is recommended to perform a careful cleaning every 2 weeks
and/or, if needed, check the pelvis positioning system in all its parts by avoiding malfunctions. Regarding the
cleaning of the padding, even if there is no direct contact with the skin, it is suggested to use a dump cloth or a
brush with natural bristles and warm water (max 60°C – 140°F), with the addition of a light gentle detergent, by
rubbing in a circular motion. Then rinse with water. Wipe out the excess of water from the padding by using a
dry cloth and dry away from heat sources. Do not expose the padding to the sun rays. Occasionally it can be
also wash in the washing machine, at max 30°C (86°F), by using a light detergent and centrifuge at a low spin.
The drying time is quite long; it is suggested to be equipped of an additional kit of padding.
The removable cover can be washed as it follows:
-
Hand wash and then air dry;
-
Washing machine (max temperature 60°C – 140°F) with the addition of a gentle detergent, bleach free, then
centrifuge at a low spin.
It is advisable to use a protective wrapping before inserting in the washing machine in order to avoid
any tearing of the film provided in the cover. It is suggested to be equipped of an additional cover.
PRODUCT TECHNICAL SHEET
www.versainserto.com
PRODUCT TECHNICAL SHEET
Page
06
Advertisement
Table of Contents
