Table of Contents
Advertisement
INDICATIONS FOR THE WIDTH OF THE SEAT
It is possible to reach the desired seat width by operating only on the flat base of construction (8) (see point a),
or on the flat base of construction and consequently on the inserts of the structural kit (see point b), or on the
inserts of the structural kit only (see point c).
a)
Flat base of construction: The flat base of construction (8) has its own sizes accordingly to the size of the
positioning system chosen.
In order to insert the base on the cloth of the seat and reach the consequent compatibility with the width of the
wheelchair/mobility system, it is possible to remove a portion of material from the sides of the base up to total 2
cm. (0.78") by using a cutter.
b)
Flat base of construction and consequently the set of inserts supplied:
After having carried out the operation of point a) it may be necessary to make dimensional adjustment of the
width of the individual insert supplied with the structural kit, by removing the necessary material using a cutter.
It is suggested to remove a small portion of material from the outer edges (max. 1 cm. –0.39") in order to avoid
affecting the concave design (4.5.6) and along the inner edges (9). Regarding the flat inserts (1.2.3) perform
this operation along the longitudinal inner edges, for the buttock guide inserts (7) perform the operation along
the inner longitudinal edges.Alternatively it can be suitable the placement of the inserts on the flat base of
construction (8) by removing the exceeding inserts; alternatively both previous operation can be adopted.It is
suggested to keep the part of material removed if not damaged by removal, occasionally, afterwards it may be
reused in order to adapt the device to the modifications made to the user. If it is necessary to reduce the depth
of the buttock guide inserts (7), remove only a small portion of material in order to avoid affecting the concave
or convex curves. If it is necessary to increase the useful length with respect of all sizes defined for each model,
it is possible to protrude each insert of the structural kit up to 1 cm (0,39") out of the flat base of construction.
c)
Set of inserts of the structural kit:
It also may be appropriate to operate a dimensional adjustment of the width of each insert of the structural kit
by removing the necessary material using a cutter. It is suggested to remove a small portion of material along
the outer edges (max. 1 cm. – 0.39") in order to avoid affecting the concave or convex curves where present
(4.5.6) and along and along the inner edges (9).Regarding the flat inserts (1.2.3) perform this operation along
the longitudinal inner edges, for the buttock guide inserts (7) perform the operation along the inner longitudinal
edges. If it is necessary to reduce the depth of the buttock guide inserts (7), remove only a small portion of
material horizontally, in order to avoid affecting the concave or convex curves. It is suggested to keep the part
of material removed if not damaged by removal, occasionally, afterwards it may be reused in order to adapt
the device to the modifications made to the user. Alternatively it can be suitable the placement of the inserts on
the flat base of construction (8) by removing the exceeding inserts; alternatively both previous operation can
be adopted. If it is necessary to increase the useful length with respect of all sizes defined for each model, it is
possible to protrude each insert of the structural kit up to 1 cm (0,39") out of the flat base of construction.
6)
Place the other inserts as necessary
NOTE: The relation of the thrust, levelling and adhesion to the user's morphology exerted by the
combined and harmonious use of each insert, enables the alignment and the postural compensation,
as well as the distribution of the body loads along all the sitting surface. Use any useful insert among
those supplied in order to achieve the compensation, support and posture correction and the
individual seat most suitable to match the anatomic shapes of the user.
PRODUCT TECHNICAL SHEET
www.versainserto.com
PRODUCT TECHNICAL SHEET
Page
05
Advertisement
Table of Contents
