Character Set Commands - Star Micronics lC-10 User Manual

Select IBM character set #7
Mode
ASCII
Decimal Hexadecimal
Both <ESC>
"7" 27 55
IB 37
Selects IBM character set #I. If the standard character set is currently
selected, this command remains dormant and takes effect at the next
< ESC > "t" I command. In IBM mode, character set #l is the power-up
default if DIP switch I-7 is OFF.
Select IBM character set #2
Mode ASCII Decimal Hexadecimal
Both <ESC>
"6"
27 54
IB 36
Selects IBM character set #2. If the standard character set is currently
selected, this command remains dormant and takes effect at the next
< ESC > "t" I command. In IBM mode, character set #2 is the power-up
default if DIP switch I-7 is ON.
Select international character set
Mode ASCII Decimal Hexadecimal
Std. <ESC> "R" n
27 82 n
IB 52 n
IBM <FS>
"R" n
28 82 n
1C 52
n
Selects an international character set according to the value of
n.
n Character set n Character set
0 U.S.A
7 Spain I
1 France 8 Japan
2 Germany 9 Norway
3 England 10 Denmark II
4 Denmark I 1 I Spain II
5 Sweden I2 Latin America
6 Italy 13 Denmark/Norway
The tirst eight of these character sets (from U.S.A. to Spain I) can be
selected as power-up defaults by DIP switches 2-2 to 2-4.
Enable printing of a// character codes
Mode ASCII Decimal Hexadecimal
IBM <ESC> I"' nl n2
\
27 92 nl n2
1B 5C
nl n2
Enables printing of all characters in the IBM character set, including those
assigned to character codes which are normally considered control codes.
This command remains in effect for the next
nl
+
n2
x 256 characters,
where
nl
and
n2
are numbers between 0 and 255.
During this interval no control functions are executed. If a code with
no assigned character is received, the printer prints a space.
65