On Line Switch; Paper Feed Switch; Print Pitch Switch - Star Micronics lC-10 User Manual

When you press the On Line switch again to go back on-line, the paper feeds
backward about one inch, stopping in the right place to resume printing.
Paper Feed switch
This switch operates only when the printer is off-line. If you press it
once the paper feeds forward by one line. If you hold this switch down, the
printer performs consecutive line feeds.
While you are feeding lines, if you also press the On Line switch, the
paper will feed to the top of the next page. This is explained later.
When power is on, always use the Paper Feed switch instead of the platen
knob to feed paper. Turn the platen knob only when power is off.
Print Pitch switch
This switch operates off-line to select the print pitch: the spacing between
characters. The indicators to the left light (green) to indicate the selected
pitch.
The printer powers up in pica pitch. To change to another pitch, press
the On Line switch to go off-line, then press the Print Pitch switch repeatedly
until the indicators show the pitch you want.
In Standard mode (when DIP switch l-6 is ON), the pitch selections
cycle as follows:
Pica
(10 characters per inch)
Elite (12 characters per inch)
Condensed pica (17 characters per inch)
Condensed elite (20 characters per inch)
Proportional pica
Proportional elite
1
This is pica (10 characters per inch).
This is elite (12 characters per inch).
This is condensed pica (17 characters per inch).
T?k is condensed elite (20 characters per inch).
This is proportional pica.
This is proportional elite.
@We Z-2. Prlflt pitches SeleCtStHe trom the COW01 panel
21