Table Of Contents; Contents; Key To Symbols; General Safety Instructions - Link Controls CDO100 Compact Series Instructions Manual

1.

Contents

1. Contents
2. Key to symbols
3. General safety instructions
4. Overview of products
5. Installation
6. Initial Operation
7. Emergency operation
8. Maintenance
9. EU Declaration of Conformity
2.

Key to symbols

Danger of personal injury!
The safety instructions must be
observed!
Warning! Danger to property!
The safety instructions must be
observed!
Information
Special information
OR
Reference to other sources of
information
2 - Door Operator / STA / LC- 2973 Rev.H
3.

General safety instructions

2 Guarantee
2
The function and safety of the equipment is only guaranteed
2
if the warning and safety instructions included in these
3
operating instructions are adhered to.
4
Link Controls is not liable for any personal injury or damage
9
to property that occurs as a result of the warning and safety
13
instructions being disregarded.
15
Link Controls does not accept any liability or warranty for
16
damage due to the use of non-approved spare parts and
accessories.
Using the equipment for its intended purpose
Operators of the STA range are designed exclusively for
opening and closing counter balanced sectional doors.
Operators of the CDO range are designed exclusively for
opening and closing roller shutter doors (complete with
installation of a safety brake as required)
Target group
Only qualified and trained specialists are permitted to install
and service the operator. Qualified and trained professionals
fulfil the following requirements:
- knowledge of the general and specific safety and accident
prevention regulations,
- Knowledge of the relevant regulations,
- trained in the use and care of appropriate safety equipment,
- Capable of recognising the dangers associated with
installation.
Only qualified and trained electricians may connect the
operator and carry out electrical maintenance.
Qualified and trained electricians fulfil the following
requirements:
- knowledge of the general and specific safety and accident
prevention regulations,
- knowledge of the relevant electrical regulations,
- trained in the use and care of appropriate safety
equipment,
- capable of recognising the dangers associated with
electricity.
Instructions for installation and connection
- The controls must be disconnected from the electricity
supply before carrying out electrical works. It must be
ensured that the electricity supply remains disconnected
during the works.
- Local protective regulations must be complied with.
- Mains cables and control cables must be laid separately.