Optex PCU-5 Installation Instructions

BATTERY OPERATED
BATTERY OPERATED
PHOTOELECTRIC DETECTOR
PHOTOELECTRIC DETECTOR
Smart Line series
Smart Line series
OPTION
OPTION

INSTALLATIONS

Using a screwdriver or similar tool, break
1
the knockout position in the back box as
shown.
4 Open the battery plate and then route the
control panel wires from the rear of the back
box through the knockout holes. Adjust the
wires so that they extend about 100 mm
from the holes.
7 Close the battery plate and connect PCU-5
male connector to the female connector of
the battery plate.
Power Convertor Unit
PCU-5
™
™

PARTS IDENTIFICATION

PCU-5 ×1, Putty ×2
Route connector cables (Alarm, Low battery
2
and Tamper) in the back box through the
hole to the battery box.
5 Fill the holes with the wires using the
supplied putty.
Control panel
8 Route the three connectors of the back box
through the slit on the upper part of the
main unit.

INSTALLATION INSTRUCTIONS

Voltage convertor unit used to enable wired
operation of the detector.
-1-
Connect the connector cable to the
3
terminals of PCU-5.
Insert PCU-5 into the slots on the back
6
box and then connect the wires to the
PCU-5 terminals.
9 Attach the connectors.
Note>>
Put the cables in order not to be caught
between the main unit and cover.
No. 59-2069-0