Data Memory; Viewing The Stored Values; Memory Full; Clearing All Values - SAN-UP BP 3ABO-H Instruction Manual

normal blood pressure – repeat the measurement. In most cases, this is
no cause for concern. However, if the symbol appears on a regular basis
(e.g. several times a week with measurements taken daily) we advise you
to tell your doctor. Please show your doctor the following explanation:
Information for the doctor on frequent appearance of the
Arrhythmia indicator
This instrument is an oscillometric blood pressure monitor that also
analyses pulse frequency during measurement. The instrument is
clinically tested.
The arrhythmia symbol is displayed after the measurement, if pulse
irregularities occur during measurement. If the symbol appears
more frequently (e.g. several times per week on measurements
performed daily) we recommend the patient to seek medical
advice. The instrument does not replace a cardiac examination,
but serves to detect pulse irregularities at an early stage.

5. Data Memory

At the end of a measurement, this instrument automatically
stores each result, including date and time.

Viewing the stored values

Press the M-button AO brie y, when the instrument is switched o .
BP 3ABO-H
The display rst shows « M » AL and «A », followed by an average
value of all readings in memory. Press the M-button again, so
the display shows «M» and a value, e.g. «M 17». This means that
there are 17 values in the memory. The instrument then
switches to the last stored result.
Pressing the M-button again displays the previous value.
Pressing the M-button repeatedly enables you to move from
one stored value to another.

Memory full

Pay attention that the maximum memory capacity of 60
is not exceeded. When the memory is full, the old values
are automatically overwritten with new ones. Values
should be evaluated by a doctor before the memory
capacity is reached – otherwise data will be lost.

Clearing all values

If you are sure that you want to permanently remove all stored
values, hold down the M-button (the instrument must have
been switched o beforehand) until « CL » appears and then
release the button. To permanently clear the memory, press
the M-button while « CL » is ashing. Individual values cannot
be cleared.
EN
7