How Not To Store A Reading; Appearance Of The Heart Arrhythmia Indicator For Early Detection - SAN-UP BP 3ABO-H Instruction Manual

5. Always ensure that the
in the pictures illustrated on the short instruction card.
•Fit the
closely, but not too tight.
•Make sure that the
with the tube on the inside of your arm.
•Support your arm so it is relaxed.
•Ensure that the
is at the same height as your heart.
6. Press the ON/OFF button 1 to start the measurement.
7. The cu will now pump up automatically. Relax, do not move
and do not tense your arm muscles until the measurement
result is displayed. Breathe normally and do not talk.
8. When the correct pressure is reached, the pumping stops
and the pressure falls gradually. If the required pressure
was not reached, the instrument will automatically pump
some more air into the
9. During the measurement, the heart symbol AT
the display and a beep sounds every time a heartbeat is
detected.
6
is positioned correctly, as shown
is 2 cm (0.75 inch) above your elbow
10.The result, comprising the systolic 7 and the diastolic 8
blood pressure and the pulse 9 is displayed and longer beep
is heard. Note also the explanations on further displays in this
booklet.
11.When the measurement has
12.Switch the instrument. (The monitor does switch
matically after approx. 1 min.).
You can stop the measurement at any time by pressing
the ON/OFF button (e.g. if you feel uneasy or an
unpleasant pressure sensation).

How not to store a reading

Press the ON/OFF button 1 while the reading is being displayed.
Keep the button pressed until «M» AL is
by pressing the M-button.
in
4. Appearance of the Heart Arrhythmia Indicator for
early Detection
This symbol AN indicates that certain pulse irregularities were
detected during the measurement. In this case, the result may
deviate from your
remove the
auto-
ng and then release it.