Operation - Johansson 6504 User Manual

OPERATION

All parameters are set with the rotary push button.
Each function and parameters are shown on 2 digits display and different LEDs .
Programming
- Make all the necessary connections and connect the equalizer to mains.
- Push on the rotary button for more than 3 seconds to enter into programming mode.
- Turn the button to select the desired mode.
- Push the rotary button to enter the selected mode.
- Inside the mode, turn the button to select the parameter (input, cluster, channels, level...)
- Push the button to confirm the parameter setting.
- Turn the button to select Exit mode.
- Push the button to confirm.
Note :
The equalizer will go in "stand-by" and will display a dot after 1 minute if the rotary / push button is not activated.
3sec.
Exit
Attenuator
Stop
Start
Filter-Input Selection
Split Input
Exit
Attenuator
Stop
Start
Filter-Input Selection
Split Input
1 2
Exit
Attenuator
Stop
Start
Filter-Input Selection
Split Input
Repeat this section to set all parameters
Exit
Attenuator
Stop
Start
Filter-Input Selection
Split Input
The software version is displayed,
followed by a dot.
Mode is indicated with
a GREEN colored LED.
= green LED
= red LED
The LED is now RED colored.
Cluster LEDs
3 4 5 6 7 8 9 10
Display
LED returns to a GREEN color.
The LED is green.
A dot is displayed.
4