4.2.4.10 Plunger Removal
1. Remove the RE (3), and disconnect loading lever of the plunger from the paper holding lever L.
2. Remove two
plunger.
Mount plunger on side frame L by tightening the two
2.
Set loading lever onto paper holding lever
3.
Hold the
cylinder, and tight screws.
—
(0) (3 X 6) screws, which secure the plunger to the side frame L, then remove the
Fig. 4-29. Plunger Removal
ASSEMBLY POINTS
and cylinder as shown in Figure 4-30, and position it where move smoothly the
Fig. 4-30. Plunger Positioning
(0) (3
and put on RE (3).
L,
//
' \
4-25
6) screws lightly.
Rubber
'\\
\
f.,
J' /
REV.-A