Set Up Instructions - Stamina Folding Recumbent Bike 15-0200A Owner's Manual

SET UP INSTRUCTIONS

Place the INTONE Folding Recumbent Bike in the area where it will be used. It is recommended that the
INTONE Folding Recumbent Bike be placed on an equipment mat. The maximum operation dimensions
of the INTONE Folding Recumbent Bike are approximately 42 1/4" long x 25 3/8" wide x 44 1/4" tall.
(These dimensions may vary up to one inch.) An area 4 feet wide x 6 feet long is required for safe operation
of the INTONE Folding Recumbent Bike. Make sure that adequate space is available for access to and
passage around the INTONE
LEVELING:
Adjust the LEVELING CAPS(50) on the REAR STABILIZER(3) so that the INTONE Folding
Recumbent Bike sits on the floor without rocking.
MOVING: The INTONE
STABILIZER(4). Fold the INTONE
tip the INTONE
FUNCTION INSPECTION:
Visually inspect the INTONE
illustration. Check the function of the INTONE
one complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(29) and
verify that it functions properly.
CAUTION:
Locate and read the WARNING LABEL(77) on the INTONE Folding Recumbent Bike. Make
sure that all users read the WARNING LABEL(77).
Folding Recumbent Bike.
Folding Recumbent Bike has a pair of MOVING WHEELS(48) on the FRONT
Folding Recumbent Bike forward to move.
Folding Recumbent Bike to verify that assembly is as shown in the above
Folding Recumbent Bike. Grasp the HANDRAIL(7) and
Folding Recumbent Bike. Turn the crank slowly through
9
Equipment Mat
(not included)