Table of Contents
Advertisement
Chapter 5
Configuring the PA-8T-232 Interfaces
Table 5-3
Examples of the interface serial Subcommand (continued)
Platform
Cisco uBR7223 router
Cisco uBR7246 router
Cisco 7301 routers
Cisco 7304 PCI Port Adapter Carrier
Card in a Cisco 7304 router
Cisco 7401ASR routers
VIP in Cisco 7000 series or Cisco 7500
series routers
Assign an IP address and subnet mask to the interface (if IP routing is enabled on the system) by using
Step 3
the ip address subcommand, as in the following example:
Router(config-if)# ip address 10.0.0.0 10.255.255.255
Add any additional configuration subcommands required to enable routing protocols and set the
Step 4
interface characteristics.
Note
Step 5
Set the clock rate using the clock rate command. (See the
section, which follows.)
Router(config-if)# clock rate 64000
OL-3562-03
Command
interface serial, followed by
slot/port
(port-adapter-slot-number/
interface-port-number)
interface serial, followed by
slot/port
(port-adapter-slot-number/
interface-port-number)
interface serial, followed by
slot/port
(port-adapter-slot-number/
interface-port-number)
interface serial, followed by
slot/port (module-slot-number/
interface-port-number)
interface serial, followed by
slot/port
(port-adapter-slot-number/
interface-port-number)
interface serial, followed by
slot/port adapter/port
(interface-processor-slot-number/
port-adapter-slot-number/
interface-port-number)
If you are configuring a DTE interface, proceed to Step 6. If you are configuring a DCE
interface, you need to configure the external clock signal, which is described in Step 5.
The example in Step 5 applies to all systems in which the PA-8T-232 is supported.
PA-8T-232 Synchronous Serial Port Adapter Installation and Configuration
Configuring the EIA/TIA-232 Interfaces
Example
The example is for interface 0 of a
port adapter in port adapter slot 1.
Router(config)# interface serial 1/0
Router(config-if)#
The example is for interface 0 of a
port adapter in port adapter slot 2.
Router(config)# interface serial 2/0
Router(config-if)#
The example is for interface 0 of a
port adapter in port adapter slot 1.
Router(config)# interface serial 1/0
Router(config-if)#
The example is for interface 0 on a port
adapter in a Cisco 7304 PCI Port Adapter
Carrier Card in module slot 3 of a Cisco 7304
router.
Router(config)# interface serial 3/0
Router(config-if)#
The example is for interface 0 of a
port adapter in port adapter slot 1.
Router(config)# interface serial 1/0
Router(config-if)#
The example is for interface 0 of a
port adapter in port adapter slot 1 of a VIP or
VIP4 in interface processor slot 1.
Router(config)# interface serial 1/1/0
Router(config-if)#
"Configuring Timing (Clock) Signals"
5-9
Advertisement
Table of Contents
