Adjust The Rollers; Load The Material - Silhouette CAMEO 4 User Manual

Adjust the Rollers

By adjusting the rollers on the main roller shaft, the Silhouette Cameo® can cut the following media sizes: A4, letter,
12 inches, and 13 inches.
Roller Head
Lock
Roller Body

Load the Material

With the material loaded on the cutting mat, it's time to load the cutting mat into the
machine. Line up the left edge of the cutting mat with the gray line in front of the carriage
and the white rollers. Click the Load button on the Cameo 4. The white rollers will grip
your cutting mat and move it into position.
The process is the same if you are loading material without a cutting mat. Just make sure
your rollers are adjusted to the width of your material (see above) before you attempt to
load it into your machine.
If you wish to adjust the starting cut point after you've loaded your material, you can use
the arrows on the control panel or in the Silhouette Studio® software.
Locate the release lever on the right side and turn it clockwise.
The roller may move out of position if not locked firmly in place.
Grasp the roller body and press the lock button.
While holding the lock button, slide the roller to the desired position. Release the
button on the roller body, and lock the release lever by turning it counterclockwise.
Silhouette Cameo® 4 User Manual
White Rollers
Lever
Load
Unload
22