Borglocks BL5000 ECP Quick Start Manual

Please check that all the parts are working correctly. Enter the factory preset code as on the code
keypad once downwards, re-enter the code and rotate the lever upwards, ensuring that the handle rotates freely each time.
The lever should return easily under its spring pressure. If you intend to change the code please refer to 'code change'
instructions this can be easily be done before or after the unit has been fitted.
Make sure that the Inside handle device rotates freely and returns under its spring pressure.
Check that the latch bolt of the latch/lock case moves freely by pressing the latch bolt at the end, the latch bolt should spring
out under its own spring pressure.
Determining the hand of the door
Many of the installation instructions refer to the handing
of the door. The hand of the door is determined with the
door in its closed position from the exterior or keypad
side of the door.
A) Right hand door – door opens inward (push), hinged
on the right side.
B) Left hand door – door opens inward (push), hinged
on the left side.
C) Right hand inward opening – door opens outward
(pull), hinged on the right side.
D) Left hand inward opening – door opens outward
(pull), hinged on the left side,
All units come preset right hand, unless you have specifically ordered left hand.
BL5000 ECP & BL5400 ECP keypads
To change the handing on the BL5000 ECP and BL5400 (non key override) keypads, this is done by removing the
grey grommet located on the side of the keypad handle; this will expose the head of the grub screw underneath.
Using the hex wrench remove the grub screw and this will allow the handle to come away from the
handle holder. Place the handle onto the handle holder facing in the correct direction for your hand of door. The grub
screw can be tightened back in and the grommet can be replaced.
BL5700 ECP keypads
To change the handing on the BL5700 ECP (key override) keypads, this is done by removing the grey grommet
located on the top and bottom of the keypad handle; this will expose the head of the grub screws underneath.
Using the hex key remove the grub screw on the bottom of the keypad. To remove the grub screw on the top of the
handle, rotate the keypad handle and this give clear access to remove the grub screw. Place the handle onto the
handle holder facing in the correct direction for your hand of door. The grub screws can be screwed back in and
the grommet can be replaced. To replace the grub screw on the top of the handle, rotate the handle. With the grub
screws tightened in position the grommets can be replaced.
Inside handles (all models)
To change the handing on the inside handle; this is done by removing the grey grommet located on the side of the
inside handle; this will expose the head of the grub screw underneath.
Using the hex wrench remove the grub screw and this will allow the handle to come away from the handle holder.
Place the handle onto the handle holder facing in the correct direction for your hand of door. The grub screw can be
tightened back in and the grommet can be replaced.
BL5000 ECP Models
Preparation
A
C
Changing the Handing of the Unit
1
card, rotate the lever on the
Inside
Outside
B
D