Bridas De Clavado Y Soportes De Montaje - Montaje Empotrado - Empire Comfort Systems Boulevard VFLL60FP90LP-1 Manual

NAILING FLANGES & STANDOFF BRACKETS - FLUSH MOUNT
Notice: You must use the nailing flanges and mounting brackets
that are supplied with the fireplace. The brackets are shipped
under the burner cover, inside the fireplace.
1. Locate the three steel middle standoff under the burner
cover. (See Figure 37)
2. The brackets have a perforation located on each end. Bend
them at the perforation. (See Figure 38)
3. Secure the standoff brackets to the fireplace top with six
screws as shown in Figure 39. The screws are located
in the hardware packet inside the envelope pack. There
are holes located in the top of the fireplace for each
standoff bracket. The hole closer to the front edge of
the fireplace is for mounting noncombustible board
around the opening (Finishing Option 1). The other hole
is for mounting the non-combustible board flush to the
fireplace face (top, side and bottom) (Finishing Option 2).
C E O
P L A
F I R E
Figure 37
Figure 38
NON-COMBUSTIBLE
BOARD ON TOP OF
FIREPLACE WITH
NON-COMBUSTIBLE
TILE, ETC. TO OPENING
I N G
P E N
Figure 39
4. On the top and bottom of each side are side framing
standoffs. Use pliers to bend the side framing standoff 90
degrees away from the cabinet. See Figure 41.
5. Locate nailing flanges in the envelope pack. The holes in
the nailing flanges allow different size boards and different
locations for the boards. (See Figure 36) Bend the brackets
at 90° angles. Install four nailing flanges with two 10 x 1/2
screws (each). (See Figure 41) The hole closer to the front
edge of the fireplace is for Installation Option 1. The other
hole is for Installation Option 2. Notice: The non-combustible
board provided is 1/2-inch thick.
BEND OUT SIDE
STANDOFFS
INSTALL (2) ON EACH SIDE
STAND-OFF
BRACKETS
SIDE FRAMING
BRACKETS
Figure 40
NAILING FLANGES
Figure41
Figure 42
Page 27