Instalación De La Placa De Chimenea Y No Combustible - Limpiar La Cara - Empire Comfort Systems Boulevard VFLL60FP90LP-1 Manual

FIREPLACE & NONCOMBUSTIBLE BOARD
1. Insert fireplace into enclosure.
2. Level fireplace.
3. Secure three standoff brackets with drywall screws to the
framed opening above the fireplace as shown in Figure 28.
Notice: The drywall screws are located in the instruction
envelope packet. Secure fireplace on left and right through
side nailing flanges.
4. Install the fireplace so that non-combustible board is installed
over the fireplace cabinet face, secure the top and side
nailing flanges flush with the face of the fireplace cabinet.
Note: Installation of a decorative front is recommended to
provide the cleanest finished look.
5. Check gas lines for leaks.
6. Plug AC adapter and LED transformer to junction box.
7. Install the wall-mounted control box within 10 feet of
the center of the fireplace. (See Figure 28)
R
C E N T E
O F
A C E
F IR E P L
8. Install a plastic bushing in both the liner and outer walls of
the fireplace. (See Figure 29 & 30)
36776-2-0816
INSTALLATION - CLEAN FACE
SCREW INTO
EACH BRACKET
T
1 0 F E E
M A X
6 " M IN
WALL MOUNT
CONTROL BOX
Figure 28
Figure 29
9. Route the yellow LED wire harness, grey remote receiver
harness,and red/black battery backup harness through the
bushings to the wall. Mount controls and connect.
(See Figure 31)
COVER PLATE
10. Set receiver in wall box to remote. Set switch on side of heat
shield to standing pilot or intermediate pilot.
Figure 30
REMOTE
SWITCH
GRAY EXTENSION
WIRE
TO FIREPLACE
YELLOW EXTENSION
WIRE
TO FIREPLACE
Figure 31
Page 23